Funktion-One Crossover Settings Reference
This reference collects the crossover configuration material used at Highpoint Studios, so a Funktion-One system can be set up consistently and repeatably. Crossover settings define the frequency points and filter slopes at which a system hands signal between its sub, low-mid, mid and high sections.
Where the crossover data comes from
The reference content is embedded from the official Funktion-One crossover settings page at funktion-one.com/crossover-settings, shown in the embed above. Highpoint Studios presents it here alongside its own documentation for its Funktion-One system.
How crossover and limiter settings work together
Crossover settings and limiter settings are two halves of a single system configuration. Crossover points and slopes decide how energy is split among drivers, while limiter settings protect those drivers. Highpoint Studios keeps a separate limiter settings page with the matching protection values.
Funktion-One products covered
The crossover reference applies to the Funktion-One loudspeaker models listed in the Highpoint Studios equipment inventory, including the EVO, F-Series, BR and RES models. See the inventory page for the exact models on hand.
Locating the full Funktion-One manual
The F1 manual page links to the manufacturer documentation. For deeper system engineering background, see the HP System Engineer CERT4 material in the Knowledge section.
Frequently Asked Questions
Contact
Reach Highpoint Studios by email or phone.
Email Highpoint Studios
P: 0417296435
Copyright 2023
Use this page as a working checklist: confirm the crossover points and slopes for each section, then cross-check the matching limiter values before powering up. Keeping both references side by side helps Highpoint Studios reproduce the same system configuration every time.